Futuretech DJ-SCAN 250 Bedienungsanleitung PDF herunterladen (Seite 11)

51839250X62NXS_V_1_1_E.DOC

11/15

Occupation mono 1/4“ jack-plug:

Tip

In Phase (+) Ground

Sleeve

DMX-512 connection / connection between fixtures

The wires must not come into contact with each other, otherwise

the fixtures will not work at all, or will not work properly.

Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with

the fixture or one fixture with another.

Occupation of the XLR-connection:

If you are using controllers with this occupation, you can connect the DMX-output of the controller directly

with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other

XLR-outputs, you need to use adapter-cables.

Building a serial DMX-chain:

Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always

connect one output with the input of the next fixture until all fixtures are connected.

Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120 Ω

resistor

between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.

1 2 ... 6 7 8 9 10 11 12 13 14 15

Keine Kommentare

Futuretech DJ-SCAN 250 Bedienungsanleitung Seite 11